This is a nice alternative to getting all your electronics charged while riding. It's a perfect fit in one of those available slots just beneath the steering wheel. installs in about 30 minutes if you take your time, you can actually just use the wiring behind the dashboard. Not recommended for a direct battery hook up because with the LED light always on it will bring down the battery. You're better off with the power coming on with a key activate power source. You can also look at our Stainless steel bolts with 1" Ram Mount ball to use with an X-Grip for cell phone and GPS.
Videos Hide Videos Show Videos
40 Reviews Hide Reviews Show Reviews
good product.....well made
Video could use a little updating. I have a 2018 Spyder RT Limited, so the video shows an older instrument panel, so I couldn't tap into the wires going to it for power to the charger. I ended up tapping into an accessory fuse in the right fusebox in the front trunk, and running a longer wire up to the charger, then running a ground wire to the engine block. That combo keeps me from always having power to the charger, and only adds power when the key is turned on.
LOOKS GOOD . FITS WELL . VERY HAPPY
Nice little addition to my 2015 Spyder RT Limited. My Garmin suffered a failure of the cover over the power button so I started using my Smart Phone for GPS. This dl-port addition makes it possible to use the phone for longer journeys. It was easy to install EXCEPT... The video shows that one must make a template for the "hole" that the unit goes into. This is unnecessary. It only requires a rectangular opening. If you use the template as shown in the video, "ears" that lock the device in place will not fit in.
Other than that little "glitch" it was straight-forward and simple to install. We are really liking this addition to the bike!
Very good product, not too difficult to install. I only ran into one little "snag". The video shows that you need to cut out a "template" for the hole in the dash. The template is WRONG. Apparently the item has been upgraded or changed slightly. Now you only need to cut out a rectangular hole for the device. The "ears" that lock the device into the dash will not go through the hole if it is cut according to the "template".
It looks really good in my 2015 RT Limited!
This is a great addition to my Spyder RT LTD! The factory missed out by not offering this.
Definitely install it in the center blank spot on the switch console so the handlebars don’t interfere.
This product arrived quickly, installed easily, and works exactly as it should. Would recommend!
Had it installed in my RT Ltd. Pierre's video was well done but I did not have the time or courage to do it. Like the look, fits in well and much easier to use than the absurd front trunk USB slot location...what was Can Am thinking!?
Installation was relatively easy, straight forward, exactly as Pierre showed on video. Just took my time and didn't rush, took about 45 minutes (including a coffee break). Hardest part was fine tuning the hole I cut for the switch to go in, but again, took my time, and made small adjustments at a time, and it now fits perfectly. Thanks Pierre